Alternativ Points for Update R6T3

[funstyler]

I search alternative Points to update the Dash.

One Solderpad are Broken.



It is a Jasper Jtag Box.

Please Help

 

[Martin C]

I don't understand the question. What exactly are you trying to do? return to stock?

 

[funstyler]

Hi, i have update the Box to 16547 over xell (rawflash).

But now i need the Avatar update.

The Resistor R6T3 is not on the Board, and one Solderpad are away. So i need some soldering, but dont know on what points.

Sorry for my bad English

 

[Martin C]

Ok - so you're under the impression that R6T3 needs to be there? It doesn't. It was removed for a good reason.

for updating the Avatar data, there's a sticky which covers this.

 

[Taijigamer2]

Update avatar/ kinect data by loading 16547 $systemupdate via USB. No need to worry about R6T3. That's just to protect fuses if u accidentally update with an official update. If its not there then u are protected. Updating with the same dash as u are on wouldn't burn your fuses anyway. If u want to return to stock then u need to replace this resistor with a 10kOhm resistor. Read this for more info.

http://team-xecuter.com/forums/showthread.php?t=62331


Edit: Martin C beat me to it.

 

[funstyler]

Ok so I've tried using the update via usb stick, it crashes the xbox off. So there must be another problem.
Should I update the Nand write again about SPI?


Perhaps an error with rawflash in Bigblock Jasper.


Thanks for the help.

 

[BL4K3Y]

A component update (Avatars/Kinect) is not the same as a full system update - refer to my sticky for more information.

You can also use the XeBuild Client Mode in J-Runner to send this data to your console.

 

[funstyler]

OK big thanks, reflash over SPI and all work correct.