JASPER Am I done for? Lifted surface mount components

[Orangeprofessor]

Hello all,

I am attempting to RGH2+ my Jasper console, but after a series of unfortunate events, about 3 surface mount components on the back of my motherboard have been lifted. And now I'm panicking.......I can't sleep.

Q: Are the components that have been lifted necessary?

Q: Should I just bridge the connections between the two points?

Q: If the components are necessary, where can I purchase them so that I can replace them?

Q: Why am I panicking so hard?!?

Link to image: (The blue wire is the CPU_RST cable) http://imgur.com/xrAth43

Sorry that the connection are a little dirty.

Any and all help is appreciated!

Best regards,
Orangeprofessor

 

[Krafter]

Your best bet would be to send it off for repair before it is too late. I don't think that it's damaged beyond repair yet......

 

[jligg]

Clean that area up with some ipa and post a new picture please

 

[lonix]

Are any of the pads missing? Hard to tell need a better photo

 

[briggs01]

as krafter said I would send it off to a pro , simply because if you have done that just by trying to RGH your console , I don't think repair is something you could do

 

[lonix]

Don't try switching it on a short near pll_bypass can fry your cpu

 

[Orangeprofessor]

Sorry for a late reply, here is the new photo. http://i.imgur.com/YekOvzy.jpg I hope this is a better photo

 

[lonix]

That's going to need some serious skillz to repair I can see 2 or more pads missing, and your pll_bypass via is all but gone