RGH Another Falcon not booting xell

[vydex]

Im having problems getting a falcon to glitch and boot into xell. Please see the pics for my installation, Im using J-runner to program RGH 2.0 for a 14719 dash, I have got my nand reading ok I have written my ecc image and flashed the ecc image to the nand, I have programmed the Coolrunner with all 4 of the relevant RGH 2.0 images to see if that was the reason it would not boot into xell. Neither A B C or D worked, once I have written the ecc I boot the xbox and I hear it trying to glitch but still no xell. J-Runner Im using is the latest one which I downloaded today. I have tried moving the wires around and still nothing. The xbox boots to retail dash with the coolrunner on norm and phat without any problems. Ive thought of trying a 50ohm wire for the blue but is there anything else im not seeing here!!! Also after a lengthy search I see a resistor could be required on D to get it to boot is that correct??

Folks any pointers would be gratefully appreciated many Thanks

 

[BL4K3Y]

First of all, I suggest you re-solder POST_OUT1.

You also need to solder a 10 Ohm resistor on CPU_RST (CoolRunner side) like the instructions tell you.

 

[Oggy]

He's using cpu_pll and not i2c, therefore, he needs to re-read the instructions for 2,0 properly.

 

[BL4K3Y]

So he is, I missed that one... thanks Oggy .

 

[GODZYLLA]

In that second pic, isn't that PLL_BYPASS? Also, the wiring seems to be for RGH1...

//Nevermind, too late

 

[BL4K3Y]

OP: You should be using i2C instead for RGH 2.0, make sure you read the information in this thread properly.

 

[trippy86]

as the others have said read the instructions, also tbh your soldering could do with some improvement

 

[vydex]

thanks for the input fellas Ive reread it and see where Ive gone wrong I was looking at a picture of the RGH1 wiring when I was doing it Im sure of it. Im going to redo as per the instructions then off to the shop tmoz to get a 10 ohm resistor.

I will also do as you suggest blakey and redo POST OUT 1

Thankyou gentlemen as always

 

[trippy86]

if i were you mate i would re do all the soldering, especially on the coolrunner. make sure you have nice sound connections with no loose strands of wire