I attempted to mod my xbox using xecuter 2.6 ce mod chip and it lit blue and switch was working but my xbox when started reboot three times and flash red and green with no audio or visual. I took out the chip today but no luck still going the same process. Plz help me
Any Solutions for "christmas lights"
- Thread starter nickyjah
- Start date
it's called frag (flash red and green)
If you search under that you'll find a ton of info on how to fix it.
If you search under that you'll find a ton of info on how to fix it.
Ok if your still getting the FRAG without the chip installed then it sounds like you have a short on the LPC ..... did you do a wire or pin header install?
a wire install coming from the chip a lot of pressure trying to install. what does that mean? i need a new xbox...is there hope..
if your box is fragging with the chip disabled, then you should completely remove the chip and the whole install to get working back to normal
check for solder splash around the install
check for solder splash around the install
The same thing happened to me last night. I installed the 2.6ce chip in my friend's 1.0 box. It was a wire install and I have done this succesfully before, but this unit will reboot two or three times and then FRAG. When I disable the chip, it works fine. I've checked all my solder points, any chance that the chip is bad?nickyjah said:
Thanks
Check your switches with a multimeter. Big_Whoopin posted a schematic that tells you exactly how to do this.