Anyone had any luck with?

[Mrbuzz102]

I have 2 xboxes here

x1 Zephyr - Dash 2.0.6717.0 - MFR - 15.7.2007 (Blade Dash)
x1 Falcon - Dash 2.0.7357.0 - MFR - 30.10.2008 (NEX dash)

has anyone had luck with either of these version before i go soldering them

many thanks in advance.

Buzz

 

[jfelding]

Ofcourse - plenty have. Recommended to update to 7371 before proceeding!
But yes, should be exploitable unless messed with by MS

 

[bailzey]

If its your first time soldering be very careful and use a 15W iron. I really messed mine up the first time, just don't keep the soldering iron on the board too long or you'll burn the pads off.

 

[Mrbuzz102]

thanks for the advice. already distroyed the jtag board lol. so looks like a wire install for now till i get me some new boards.

why update to 7371 before proceeding? is 7371 kernel not a bit dodgy? really dont want to update just incase something goes wrong.

 

[jfelding]

thanks for the advice. already distroyed the jtag board lol. so looks like a wire install for now till i get me some new boards.

why update to 7371 before proceeding? is 7371 kernel not a bit dodgy? really dont want to update just incase something goes wrong.

http://www.team-xecuter.com/forums/showthread.php?t=54670

Some users dont update without problems.
7371 is fine as long as your motherboard version isn't post june 2009, these will still be vulnerable.

 

[Mrbuzz102]

thanks for the advice will give this a go. would i be best dumping the nand a few times first. then update the dash?

 

[jfelding]

thanks for the advice will give this a go. would i be best dumping the nand a few times first. then update the dash?

Not really

 

[bailzey]

Download the update (if you haven't already) http://www.mediafire.com/?zrugemuynvn. Then just put it on the root of a usb stick plug into the console, turn it on and it should ask you to update.