ANSWERED applying RGH on Jasper

[Mad wolf]

hi all ...
i gotta Jasper 16mb NAND ... and planing to apply RGH on it, i have every thing ready .... but m mind not ready ! bcoz all reports of jasper i had seen, also we tried m friend's console which it was da same jasper 16mb with no luck
- slow boot time , mostly not boot at all ... etc
so , am a little confused ! what should i do ?
try m luck ? .......... or step back ?

 

[BL4K3Y]

Glitch the console first, read this excellent guide.

Small block Jasper units shouldn't need the cap, all I can say is get everything installed and write your glitch image then post back with any issues.

 

[Mad wolf]

thnx 4 da reply ....
i jst wanna check da water b4 i swim .... i mean i wanna know da [chance of success] for Jaspers if every thing gone well (good solder ... etc), since i had read many many reports of fails, not boot, freezing .....
so i may exchange it with Slim b4 i put my solder in !!
thnx ...

 

[BL4K3Y]

If you have an exploitable CB (6750/6751), you will be fine.

You can check the CB (2BL) in 360 Flash Dump Tool once you get a valid NAND dump .