Earlier i had ordered the r jtag kit after about 3 days of 8 hour sessions trying to install it i realized that i have no idea what the hell im doing so i removed all of the chips and cleaned all of the solder off but now my 360 wont even turn on what happened here? how do i fix it
Attempted mod chip install gave up Now my console wont turn on
- Thread starter rydroid
- Start date
Pics are a must please fill out this template. Is this the same system as your other thread? You flashed back the original nand...need to see the points the qsbs were soldered to now that they are removed etc. Looking at the other thread is the resistor on R2P12 damaged or even there? Time to send it out to someone who can solder/repair. Patience or it ends up in the bin i said in the other thread.
Last edited:
Well that was do to soldering/lack of understanding. This is not car wiring. Flux is a must and a proper read through of the stickies so you KNOW what you have to do before you attempt an install. You can put in a request for service I am sure someone near you can get it going.
Last edited:
Don't give up man, just takes practice and the right tools. Get a basic understanding, read information and start with a normal rgh or jtag and get the feel from there.