I have a jasper 256, nand-x and coolrunner
Wired up nand-x to proper points on the mobo. Updated jrunner to latest version. Proper drives installed.
I click read nand for 2 times, and jrunner reads the nand successfully.
Compared nands - succesful
Programmed coolrunner, timing A successful
Create ECC - successfull
Write ECC - fail with errors
Tried read nand again and got error 204 block 1, 204 block 2, 204 block 3, 204 block 4
Now the console wont even turn on. No CR light green or red is valid unless connected via usb to my laptop.
Console will not turn on, so i can't boot into xell
Failed at write ecc
I have desoldered nand x and CR from the mobo - still no power, and yes psu is connected
Is there a current way to recover the dead paper weight?
Wired up nand-x to proper points on the mobo. Updated jrunner to latest version. Proper drives installed.
I click read nand for 2 times, and jrunner reads the nand successfully.
Compared nands - succesful
Programmed coolrunner, timing A successful
Create ECC - successfull
Write ECC - fail with errors
Tried read nand again and got error 204 block 1, 204 block 2, 204 block 3, 204 block 4
Now the console wont even turn on. No CR light green or red is valid unless connected via usb to my laptop.
Console will not turn on, so i can't boot into xell
Failed at write ecc
I have desoldered nand x and CR from the mobo - still no power, and yes psu is connected
Is there a current way to recover the dead paper weight?
