DRIVERS Autobaud Failed - Step 1

[Mikebyrne]

I'm trying to update my nand x but im getting the "Autobaud Failed - Step 1" error

I'm using a Xecuter CK3 Pro, in the device manager its listed as COM 3 but under "Prolific USB to Serial COM Port"

Is this where I'm going wrong??

(I've also soldered the extra wire just in case I needed to)

 

[Disk0]

You only need the extra wire on the rev D, and did you try changing to frequency as suggested in uber's guide?

 

[niallo27]

Quick thing to check have you the ck3 switched to usb or com.

 

[Mikebyrne]

Quick thing to check have you the ck3 switched to usb or com.

There's no switch on my revision, its the older on

You only need the extra wire on the rev D, and did you try changing to frequency as suggested in uber's guide?

What do you mean by "changing to frequency"?

 

[Mikebyrne]

Tried the on/off trick and it worked!!