Bad block problem with Jasper RGH

[thedemon13666]

Hello,

I am currently trying to RGH my jasper but it appears I have a bad block at 039, which I know is a problem.

I have tried using this tutorial,
http://team-xecuter.com/forums/showthread.php?t=76014

But it hasnt made a difference,

When I try to boot my console it hangs on a black screen.


I have been using coolshrimps jtag tool

 

[WNYConsoles]

Try XNAND healer. Make sure to flash with RAW FLASH V4.

What was your original NAND Dump Dashboard Version?

 

[thedemon13666]

IS RAW FLASH V4 on coolshrimps jtag tool?
I dont remember the actual dash but it hasnt been updated for awhile so I know that it isnt past the glitchable dash versions

 

[thedemon13666]

Really dumb of me but I couldnt find the EDIT button on the thread.


I should note that I read my nand 4 times and they all matched with the same bad block

I had a look at XNAND healer but was a little confusing.
On Remap bad blocks tab I selected nand.bin in the 'from file' part. I then selected nand4.bin in the 'nand to be remapped' part.
I then hit remap.

It told me it had remapped the blocks, so then using coolshrimps I made a new ecc file and trying flashing it but it still said error writing block 39.....

 

[Martin C]

Both XNANDHealer and J-Runner should sort the ECC bad block for you when you write it.

Yes, you'll get an error writing block 39 as it's a BAD BLOCK (you already know this, hence the topic you started).

You CANNOT fix a bad block, so it's remapped as per the tutorial I wrote.

 

[thedemon13666]

Ok so if I am still getting a black screen is that not down to it being a bad block problem?

 

[WNYConsoles]

Do you see the green debug LED on the CoolRunner? Is it a REV B CoolRunner? If not REV B you may need 68nF capacitors on Groun/PLL and possible in-line RST.

EDIT: If you do have REV B CoolRunner make sure to bridge solder the CAP point.

 

[thedemon13666]

I do have REV B.

where is the CAP point?

---------- Post added at 11:06 ---------- Previous post was at 11:04 ----------

EDIT:

I have found the cap point, what does this do?
I only have a 16mb jasper btw..

---------- Post added at 11:07 ---------- Previous post was at 11:06 ----------

FURTHER EDIT:

When I turn the box on the green light flashes, I assume thats suppoed to right?

---------- Post added at 11:09 ---------- Previous post was at 11:07 ----------

FURTHER FURTHER EDIT

I went ahead and did it. Xell came straight up.

I love you
so very much

 

[WNYConsoles]

Glad I could help. A thanks is appreciated

 

[DigitalMerchants]

I do have REV B.

where is the CAP point?

---------- Post added at 11:06 ---------- Previous post was at 11:04 ----------

EDIT:

I have found the cap point, what does this do?
I only have a 16mb jasper btw..

So you are saying you were doing all this without reading ANY of the official instructions

:facepalm: