JTAG BAD FLASH RECOVERY SLIM

[CheoS]

Sorry... This worked.. The ALT_STBY_CLK TUT was just updated and the point was wrong in the image. As soon as it was updated, this worked fine..

Thanks Great TUT

 

[RavenPhoenix]

Sorry to bring this back from the dead but I just got a question regarding where to connect the ground? I am clear with the 5v but where does the ground connection go?

 

[sthetix]

There are a few solutions around if you cant read your NAND due to bad flash.

One of them is a 5v mod where you connect a 5v power source to a specific capacitor thus getting power to NAND and hopefully reading it:

http://forums.xbox-scene.com/index.php?showtopic=700983

I have been searching the net for a similar solution for Slim consoles but couldn't find one. So I had to come up with one myself, and here it is:

Near NAND chip there are two resistor pads. Connect an external 5v power source to the pad on the right and a wire to GND. Thats going to power NAND, J2C1 and J2C3 enabling to read/write nand.

hello, i have a trinity that won't boot (no power just beep only). I cannot read or write its nand. i tried bad flash recovery http://team-xecuter.com/forums/showthread.php/52213-Bad-Flash-To-Nand-How-To-Recover-! but it just won't work. Can I try this method? There is 3.3v when i check R1D5