RGH BB 512 Jasper DVD reading...

[X-R4Y]

Hi,

i soldered the CR succesfully, put the wires as shown in the pictures posted by uber. It has been programmed with jasper.xvsf via nand-x. It glitches everytime within some seconds, Xell is loaded everytime if i push the eject button. I´ve made the glitch_image with nand-healer 0.74.

If i attach a DVD drive, it boots to 14699 dash and shows "reading..." all the time (no dvd inside) and mostly locks up there. If i remove the DVD drive cables the console is working within dash without lockups.

I flashed the correct dvd-key from kv (doublechecked with flashtool 0.97).

Any hints?

 

[BL4K3Y]

I haven't used NAND Healer, can you recall if it said anything about FCRT.bin?

You need to extract it from your stock image if it is available and use it with your glitch image (360 Multi Builder does this automatically).

 

[X-R4Y]

Yes, it says it is missing. How do i extract it from my stock-nand?

 

[BL4K3Y]

Use FCRT Extractor by BestPig or run your NAND through 360 Multi Builder to build your glitch image again, that will automatically extract FCRT.bin and use it .

 

[X-R4Y]

Hm, will give it a try. I thought NAND Healer is using multibuilder automatically because i set the directory for it?!

Is multibuilder saying anything about fcrt.bin while creating the image?

 

[BL4K3Y]

As I said, I haven't used NAND Healer so I don't know... Multi Builder will tell you if FCRT.bin is found or not .

 

[X-R4Y]

Hm, multibuilder 0.7 doesn´t mentioned anything with fcrt.bin. :-(

Edit: If i have a dvd-drive attached with the multibuilded image, the lockups occur while bootscreen or while configuring first time. If i remove the drive, everything is fine

 

[BL4K3Y]

If the file is found, Multi Builder will tell you.

 

[X-R4Y]

Hm, then nothing is found as it seems.
FCRT Extractor says "incorrect file size" (tried v0.3) from my nand-image (64mb dumped as stated in the tutorial)

 

[Martin C]

Wait a mo - Jaspers don't have fcrt.bin.

Check your soldering points. If this was working before you started, you've damaged something along the way.

 

[X-R4Y]

I triple checked all soldering points. If i flash the original 64mb nand-dump back, everything is fine. So soldering should be fine also i think?

 

[BL4K3Y]

Not necessarily, you don't need the CoolRunner or any of the solder points for the console to function with your original/stock NAND written.

 

[X-R4Y]

Well, then no rgh as it seems with this one Leaving it on stock, then it is working

 

[Martin C]

Might have been a corrupt block during the write process. Did you flash using rawflash v4 or nandpro?

 

[X-R4Y]

Tried both, first rawflash v4, then i tried to do it with nandpro via nandhealer.

I will try to do a fulldump of nand now.