ANSWERED BB Jasper Update NAND, not booting Glitch image but boots Xell fine

[mechgamer123]

I got this system back in to update today:
http://team-xecuter.com/forums/show...t-Glitch-image?p=912420&viewfull=1#post912420
I tried to write the update to the DemoN NAND, selecting both the 16MB option and the advanced 16MB Small block controller thing. I also tried writing the image normally, and also writing it by enabling the noremap option and then writing the image with the "DemoN Write" option in advanced. I also tried checking "sets UART speeds during bootstrap to demon compatible speeds" but I still wasn't able to get the system to load the glitch image.
Finally, I tried using the nointmu option in xebuild in addition to the other two options, and it still wouldn't boot the glitch image.
Xell reloaded boots fine in all configurations though.

Any help or suggestions would be appreciated, thanks in advance!

 

[Martin C]

Why are you selecting 'the advanced 16MB Small block controller thing'? Where does it say to do that?

 

[mechgamer123]

Why are you selecting 'the advanced 16MB Small block controller thing'? Where does it say to do that?

Nowhere; I am just stating that after trying all the above motioned configurations when selecting the regular Jasper 16mb, I tried the advanced Jasper 16mb SB controller as well on the off chance that might solve the problem.

 

[gavin_darkglide]

I try writing back the old image that was on the demon, install latest dashlaunch and use updserve and j-runner v0.3 to update across network.

 

[mechgamer123]

Looks like I don't have the old image that was on the DemoN unfortunately...

Edit: It works now. Please close the thread.