BB Jsaper RGH 1 to RGH 2 w/demon

[pipadee2010]

Hi there everyone im thinking of changing my bb jasper from RGH 1 to RGH 2 i just need to know if its a straight forward getting a CR rev C and re wiring or will it mess my xbox up if some pics or a video were available i would have a crack at it but not sure whether i have to start from scratch and de solder it all ???

will it affect the way I have already written my nand???
(switching from 1 to 2??)

Can anyone help me please I want to upgrade then fit a demon

 

[Utmad]

Until the modification comes out for the phat small block demon you cannot fit a demon to a bb jasper.

To go to rgh2 you would have to re-wire and create a new rgh2 freeboot image for the nand.

 

[-DoC-]

It wouldn't be hard to do if you did your RGH1. RGH2 takes a bit more work with routing the wiring to get good glitch times but aside from that the RGH part is easy. The demon takes a bit of skill to solder and should be done by a professional.

But as UT said, there is no use with even going through any of that as you can not install a demon on a BB at this time.

 

[pipadee2010]

cheers for the info utmad and -doc- just gives me a rough idea for when the conversion kit is sorted didnt want to mess the xbox up soldering is good though when i aint been on the Jack D night before lol

 

[-DoC-]

I wouldn't advise you to be under the influence while soldering the Demon. :cool2:

If you have a good hand at soldering it's not that bad.

 

[Krafter]

You do realize that you will have to downgrade the BB NAND to a 16M right?