Hey guys i have searched long and hard and cant find out what to do. I have a benq drive that was originally flashed with LT+ firmware back in december. I was upgrading to 1.91 and things went smooth. when i tried to put in a game it made me upgrade dash and half way there i got the error 3151-335a-b800-0f00-c000-0059. I tried to reflash to stock hardware and possibly screwed things up. I can no longer get into vendor mode and if i try to put a disc into the xbox it starts to load update then turns right back to error message. I have tried to USE BENQ UNLOCK and intro/device id methods and it keeps failing to go into vendor mode. Any suggestions on what I can do? Im not horribly computer smart but i can find my way around pretty well. Thanks in advance for the help
JUNGLE FLASHER benq drive wont go in vendor mode
- Thread starter mgntwo1
- Start date
im using an on board sata, my drive pops up the left hand side and tries to go in vendor mode but always fails
cypher21
VIP Member
If you have a PMT or probe 3, try the badflash method to kick it into vendor (See JF tut for a pic of MPX01 for benq)
do you not think it wiser to check if the op has his tray halfopen before going into bad flash methods if he's not so good with computers as stated?
so matey is the tray half open when you try?
so matey is the tray half open when you try?
cypher21
VIP Member
i have tried the half open method and turning off then on the xbox real fast it still does not do anything. Where is the badflash method located? thanks again for the help guys
BL4K3Y
VIP Member
Download and read the official JungleFlasher tutorial, the bad flash/recovery methods are explained in there.
im sorry guys i am an idiot, i tried to flash my drive back to stock not realizing that my stock save on my computer was actually with 1.6, so benq unlock wouldnt work. sswitched methods and worked fine. :facepalm: