LITEON 0225 bigjohn0513


Full Member
Dec 16, 2011
I have my CK3i, X360USB Pro and the PCB replacement board for my slim 0225 Liteon (that is the firmware on the label) and I've been following the guide at

the only part that I can't get past is the getting the drive to be recognized by my computer. I've flashed a lot of drives but never a slim drive so this is new to me.

I would post my JF log but there is no use if it doesn't even recognize the drive.

I am running JF 1.92 and I have the iXtreme LT+ 3.0

I've already updated all my software, I've tested the points throughout the drive for voltage and it is there.

Also I have the new pcb 1.1 board with the lock unlock small board that sticks out but I can't find a specfic tut for this board yet.
Last edited:


Senior Member
May 12, 2012
the tx pcb's are BLANK when you recive them. I did not know this I just READ the tut and the answer was there.

thanks to ubergeek!! great tut


VIP Member
Jan 20, 2011
Exeter UK
I returned my tx board to stock earlier for the impending update - could not have been easier with my new shiney x360 usb pro 2 :D

As uber said follow the jf guide, if you get trouble post your jf log

You need to dump your key from the 0225 board first - have you got that far?
Last edited:


Full Member
Dec 16, 2011
I got the key before I installed as the tut stated it when I READ it.

The 0225 v1.1 replacement drive is in and I didn't see anything in the tut about hitting the "intro" button under the "MTK Flash 32" tab.

Has the replacement v1.1 0225 drive have known problems being detected?


JungleFlasher 0.1.92 Beta (304)
Session Started Thu Jun 14 22:03:39 2012
This is a Wow 64 process running on 4 x 64 bit CPUs
X360USB PRO detected, Version 0.18
Found 1 I/O Ports.
Found 1 Com Ports.
Found 6 windows drives C: D: E: F: G: H:
Found 1 CD/DVD drives F:

No Drive Detected! DVDkey files extraction aborted!