Black screen after sx os installation

tripleQ

Noob Account
Jul 14, 2019
9
1
Europe
Ok so i just installed sx is 2.8 ok my switch, activate the license and put it in the Sd card
After injecting the payload again and pressing the boot cfw (emunand enabled) my switch just went black. I’ve tried various things without success so it would be awesome if some is able to help me out here
 

imprezgc8

Majora's Mask
Staff member
Troll Eating Dogs
Nov 26, 2007
2,018
108
The Cloud
What FW are you on?
Are you using exFAT?
Does your Switch support exFAT?
 

imprezgc8

Majora's Mask
Staff member
Troll Eating Dogs
Nov 26, 2007
2,018
108
The Cloud
my switch is on 8.1.0 and it does support exFat
Do you have a clean/any nand back up already? Just curious if it boots CFW with emunand disabled.
 

tripleQ

Noob Account
Jul 14, 2019
9
1
Europe
Do you have a clean/any nand back up already? Just curious if it boots CFW with emunand disabled.
I don’t have one yet
And when I boot my switch with cfw disabled there’s blackscreen as well, hell even clicking on booting the original FW there’s blackscreen
Do you have a clean/any nand back up already? Just curious if it boots CFW with emunand disabled.
The switch starts normally outside sx os though
 

imprezgc8

Majora's Mask
Staff member
Troll Eating Dogs
Nov 26, 2007
2,018
108
The Cloud
Ok. So it doesn't work when you try to boot CFW only?

I would make a fresh nand back up so you have it and then create a new emunand and try again.
 

tripleQ

Noob Account
Jul 14, 2019
9
1
Europe
Ok. So it doesn't work when you try to boot CFW only?

I would make a fresh nand back up so you have it and then create a new emunand and try again.
I’ve tried to reinstall many times but same result.
I was thinking maybe 8.1.0 is not supported yet or something