"Blank Screen After Flash X3" - How to fix it with a Solderlessadapter?

[MasterStream]

Hi,
i am using the X3 modchip with the EvoX M8 Bios, because I couldnt flash the X3 BIOS. It is the problem with the "Blank Screen After Flash X3" (=> Sticked Thread).
The Thread tells me to solder some Pins again, but how could I fix the Problem when i am using this Solderless Adapter: http://konsolenprofis.de/shopbilder/xbox/xz0464.jpg ???

 

[Martin C]

The blank screen after flashing has nothing to do with the soldering in your case, for two reasons:

1. You're using a solderless solution.
2. It only applies to X3 BIOSes.

What was the filename of the Evox M8 BIOS you used?

Incidentally, all BIOSes can be gotten from Xbins.

Martin

 

[MasterStream]

Thanks for the quick answer.
I am sorry, my English is probably not the best...
what i wanted to say is that i have now a working M8 on my chip, thats fine, but I wanted to make the X3 BIOS on my chip which doesn't work...(=> in this case, I tried to flash the M8 and it worked but the X3 Bios is much more better I think)

(The X3 BIOS I tried to flash, was from XBins... "X3 3294.bin")

Johannes

 

[Martin C]

Because you're using the solderless adaptor, you need to make sure all pins have 100% contact with the LPC points on the board. You may even need to clean the LPC points with some acetone (nail varnish remover) or a stiff eraser. The BIOS mentioned should work as long as you're booting it from one of the 1MB banks.

Martin