Blaster CK3, probe3, 0251

[rozilipo]

Yes, JF says "Serial status found with 0x52"
Yes, it says "extract complese, switch off, 5 sec switch on"... Switch on and off I mean using the switch I added on the cable (also I see the Probe3 led on and off).
I do it (removing probe or leaving it on the pont), but when clicking ok it says "Phatkey failed". Tried to wait 1 sec, 5 sec, 20 sec, tried to push Ok then switching on, tried to push in the same time than switching on... tried in vendor mode, tried normal...
Please help me

 

[reefz3ro]

have you tried it with mini probe that came with blaster?

 

[rozilipo]

No probe has come with Blaster.
I had to buy it in a second time.

 

[BL4K3Y]

When you are asked to power off then back on, remove the probe, switch off, count to 5, switch back on and then click OK.

You cannot use the Mini Probe for PhatKey, that ONLY works with Lite-On 74850 drives and the DVDKey32 feature (now obsolete).

 

[reefz3ro]

Ok so i went back and flashed my phat lite-on with stock 02510c firmware and tested key extraction with mini probe that comes with the ck3 blaster. adding the switch like i said to the 3.3v works to get the key. Which i already knew as i have done this already but i wanted to go threw the process again to refresh. Also the Mini probe that came with the ck3 blaster when used with the Probe3 cable will also extract the key.

These are the steps
1. make sure jungle flasher see's your dvd drive
2. go to DVDKey 32 and click phat key
3. shut the power off to the 3.3v and click yes
4.touch probe to MPX01 and turn power to 3.3v on
(now it should say extract complete)
5. turn power off to 3.3v and wait 5 seconds
6.turn power to 3.3v back on
7. click yes
8. now it should start asking you to save your files (key.bin/dummy.bin ect.)

Now if your using the probe3 i assume it should work as well but i dont have one to test with the blaster.

Im leaning towards one of 2 problems 1. your onboard sata is giving you your issue(im using a usbpro) 2.Just plain user error.

but in any event you can get your key with just the CK3 Blaster and mini probe with switch to 3.3v. providing a good sata chipset communication.

 

[rozilipo]

The steps I used at first were the same than the yours.
Yes, at point 4 JF says "extract complete", so the dialog pc/drive should be good.
But at point 8 it shows "phatkey failed".

The cable come with probe3 does not work with blaster ck3. So I cut the cable of blaster ck3 putting on the switch (which it should work, because I see the Probe3 led going off and on).
Should I keep away the Probe3, the Blaster ck3 and get a Pogo?

 

[reefz3ro]

Should I keep away the Probe3, the Blaster ck3 and get a Pogo?

I'm not sure i understand your question.

If you have done the steps above and feel that you are doing them correctly and it's not you the user that is the error, I would be willing to say its your onboard sata connection that is giving you your problems and you need to get a usbpro.