Blinking Green light on CR but no display on TV

koolbreeze

Noob Account
Feb 1, 2014
3
0
Hi all, first of all would just like to say thanks to everyone on this forum, I have been reading and learning so much from everyone's post and responses.
Having attempted to install a CR on my XB (zephyr mobo ) I have fallen at so many stages but having read everyone's issues I have manged to overcome them one by one but have now hit a brick wall. the story so far:-


  • Read Nand with Jrunner and Nand-x (finally)
  • Compared successfully
  • Soldered CR on mobo (see pics)
  • Flashed the CR first time (go me!)
  • Created ECC
  • Wrote ECC to Nand successfully
  • Disconnected Nand-x
  • Attempted to boot in xell (no display on TV)
  • Attempted to boot normally (no display)
  • Turned off CR and booted (still no display)

I know my soldering isnt 100% perfect but I have re-soldered these now about 6 -7 times

Any advice would be appreciated, let me know if you need any more info from me.

Thanks in advance.
BLUE.jpgGREEN.jpgYELLOW.jpgORANGE.jpgCR.jpg
 
Last edited:

BL4K3Y

VIP Member
Top Poster Of Month
Jul 7, 2010
13,062
118
At Home
What is the console's CB version?

Bridge the "CAP" pads and see if that makes a difference.
 

koolbreeze

Noob Account
Feb 1, 2014
3
0
Bridged CAP pads but stills no display.

Template below:-

TX Product(s) used: NAND-X
Console Type: Zephyr
NAND size: 16mb
Dashboard version: 2.0.14699.0
CB version: 4578
Screenshot of NAND details from J-Runner: Attached Below
J-Runner log:
updflash.bin log (if applicable):
Image of Coolrunner: See Previous Post
Images of close-up soldering to motherboard: See Previous Post
Description of problem: Blinking Green light on CR with Solid Red light no display on TV via HDMI or AV

Was the console working before you started: Yes

Do you get a green debug light appear on the RGH chip every 4-5 seconds: Yes

How long is the light on for each time: approx 5 seconds
jrunner ss.jpg
 

xzanox

VIP Member
Nov 1, 2011
905
48
Netherlands, 1336
Well your coolrunner soldering is very bad, giving you most likely the non function problems you're having, and i don't know when you took that picture, but the switch is still on the program side, so booting to xell will become difficult.

I think is wise to make a few more pictures of the coolrunner and how everything is connected topside and downside (wire routing etc), and resolder the coolrunners wires. Then try it again.

Btw it's also smart to update jrunner, see the green line on top of jrunner...
 
Last edited: