Block codes

[xWeasel]

Since it's not reading anywhere near it should (and I assume the console still boots), check the area for that point.

You might just have a failing SPI in the southbridge.

ah i see, ill try re-soldering that point and hit you up with an update

 

[xWeasel]

Since it's not reading anywhere near it should (and I assume the console still boots), check the area for that point.

You might just have a failing SPI in the southbridge.

re-soldered the point on, and now it gives me the correct v (3.2v)
tried to read the nand, and this error again:
Version: 10
Flash Config: 0x00000000
Can not Continue

 

[Martin C]

Retouch all points - if that's just gone from 0 to 3v3, you have more than that as a problem.

Use plenty of flux and desoldering braid to remove as much of the old solder as possible, then retouch.

 

[xWeasel]

Retouch all points - if that's just gone from 0 to 3v3, you have more than that as a problem.

Use plenty of flux and desoldering braid to remove as much of the old solder as possible, then retouch.

okie dokie, does it mater what flux i use? because i done use the ones in the tubes

 

[Martin C]

Use flux made for the job. Water based, non-corrosive.