boot to bios again?

[aceman118]

I set an option to not boot to the x3 bios and now i need to boot to it again cause i installed a new HD. how do i do this? thanks.

 

[scottevil]

press the white button during startup.

 

[aceman118]

I tried. Doesnt seem to work. It just goes right to the MS dash every time. I cant seem to ftp into it (i was able to before) cause my settings arent right and the only way i know of is to get to the bios.

 

[rasgal]

if it's X3 live config you want into

press and hold back+start , and don't release them before it shows up(some seconds).

 

[aceman118]

i figured it out. im just dumb. i have the switches wrong and i didnt install the dash right.

 

[yourM0M]

if it's X3 live config you want into

press and hold back+start , and don't release them before it shows up(some seconds).

back + start....come on man seriously dont tell ppl sut to do if you dont know wut your talking about!!
where are you getting this info from anyways??

 

[flycom]

Identifying what drive type in your 360 the easy way!

[align=center]There is an easy way to determine what drive you have in your console without actually fully disassembling it, all you need do is remove the faceplate (see image below; turn the console sideways with the power button facing upwards and pull outwards from the very edge of the faceplate)

Then check the hole in the front of the dvd drive, refer to the image below :

There, saves alot of hassles with identifying your drive make, you then know what you are in for before even full disassembly.

If someone can identify the original owner of these images, I will more than happily give credit for it.[/align]