ANSWERED Booting Problem.

[seaeye]

I have a jasper sb here. All wires secure. Ecc image flashed on.When i press power button or eject button middle button just flashes. Doesnt boot.

Anything?

[ame]http://youtu.be/OEBTWH7fbiE[/ame]

 

[BL4K3Y]

Is your CoolRunner chip programmed with the Jasper fileset?

Also, did you add the cap to the CoolRunner as per this image (across CPU_PLL_BYPASS (point A) and GND - thanks to seanr28)?

 

[CNGHacKSs]

I have a jasper sb here. All wires secure. Ecc image flashed on.When i press power button or eject button middle button just flashes. Doesnt boot.

Anything?

so it look like u fix the flashing cr problem
good

now does the cr blink green or only solid red

 

[cskalash]

Did you opened your nand image in 360 flash tool and confirmed your cb is not 6752.
If it is you will not be able to rgh it

 

[hodgie]

after install ecc file no booting no xell just a green light blinking my xbox 360 jasper 16m cb6750

You should start your own thread. Hi-jacking will get you in trouble. Just a heads up.

 

[seaeye]

Is your CoolRunner chip programmed with the Jasper fileset?

Also, did you add the cap to the CoolRunner as per this image (across CPU_PLL_BYPASS (point A) and GND - thanks to seanr28)?

I did not add the cap. It is a 16mb. Didnt think i need to. Now its not blinking. I check the nand in 360 flash tool and it said bad kv on the right side? I gave it to my friend and he wrote me an image

 

[hodgie]

It will say bad kv until you input the correct CPU key.

 

[cskalash]

You may not need the cap, not all the jaspers need it, but in all the cases i tried you'll benefit from it.
With those symptoms you should really try the 68nf cap on CoolRunner from pad A to Ground.

 

[coolkiddj12]

We need some pictures of your soldering. Im just curious to see if everything looks fine.

 

[gazzaman2k]

if you wrote the ecc image did you take a backup of the nand to begin with? if so flash the original flash back to the console and desolder just the power load from the cool runner and try boot it.