Then i sugest writing xell to the board, i dont think theres anythink but the standard smc for xenon so theres no choises. Make sure you have a good dump of whats on your nand now, as i said there might be something usefull in it.
That's what i would do, if i knew how to change the Launch settings. I want the Xell to boot up immediately when i turn it on. The Sync Button and the Dvd Drive button are soldered. (It was from the seller like that)
If you flash Xell, nothing else than xell will boot and it will boot with your power button. What did you expect to boot with xell flashed?
Really? Well, Do you have aim? I want to make sure the settings are right and stuff.
Aim? I dont know if xenon_hack.bin is included in jrunner but if its not and you cant make a xell image from whats left of your dump, get it downloaded and flash it to your nand.
It stopped blinking. It doesn't give video though. Tested it on 2 tvs. Although, i lost the original AV to this xbox, so i used the one from my slim
It should give you video, but if it doesnt you could always see if you can fetch your key by http or ip.
Its described in the jrunner manual but you need to connect your xbox to your router, power it on and a minute after it stopped blinking you click the scan ip button in jrunner or connect to your router to see what ip-adress it have been assigned and enter it in jrunner.
Ok, i flashed it again, but it keeps blinking. It has been like this for like 2 minutes. Also, when i hit Scan For IP, it comes back with "Xbox Not found"
If it doesnt stop glitching its something wrong, might be a corrupt xenon_hack.bin or you have a hardware problem.
