RGH bridged points

[WalangAlam]

I'm getting bridged solder points. Could somebody check if the soldering points are right?

http://imgur.com/oNxfS

there are 5 soldering points in the E F 3.3v area right?

 

[Martin C]

They should not be bridged. Apply plenty of flux and get some desoldering braid. If you're lucky you'll be able to draw it out.

 

[WalangAlam]

They should not be bridged. Apply plenty of flux and get some desoldering braid. If you're lucky you'll be able to draw it out.

are those the only two points I should check? underneath the board is untouched and ok. Can the two points short in the coolrunner area given one is the 3.3v?

There are 5 soldering points and the points I shouldered into are correct right?

 

[Martin C]

The points you have bridged are a mix between one connection for the NAND-x and the 3.3v standby point. Point F is UNDER the 3.3v one.

 

[WalangAlam]

here's the cr

http://imgur.com/8adNk

all my connections in the cr are correct right?