Hello.
Recently I did RGH with my console, and all were OK. But after I change thermal paste under CPU and GPU, I accidentally broke CPU_PLL_BYPASS point and resistor after it. Then I restore that point from top MOBOs site, put resistor, and all seems OK, than I use multimetr to check it.
BUT without DVD drive my console doesn't boot XELL just blinking central green LED on power button. If I connect DVD drive, console also doesn't boot, but LED central LED flashing constantly.
If CPU was burned (maybe with short circuit), should console run this way? Or something else?
(Sorry for bad English
)
Recently I did RGH with my console, and all were OK. But after I change thermal paste under CPU and GPU, I accidentally broke CPU_PLL_BYPASS point and resistor after it. Then I restore that point from top MOBOs site, put resistor, and all seems OK, than I use multimetr to check it.
BUT without DVD drive my console doesn't boot XELL just blinking central green LED on power button. If I connect DVD drive, console also doesn't boot, but LED central LED flashing constantly.
If CPU was burned (maybe with short circuit), should console run this way? Or something else?
(Sorry for bad English