Bumped off a tiny resister while soldering the PLL wire on a falcon

BlueFoot

Noob Account
Dec 4, 2019
1
1
USA
Sorry if this is the wrong place, but I could use some help reading the schematics....

I believe I need a 10k ohm resister to replace, it but I'm not even sure If I can replace it as I only have one pad left from what I can see.


this is the resister I yeeted out of the arena, as you can see its just riiight above PLL heres a photo of my board

Is it possible to revive that small resistor, I have an old dvd drive with plenty of 10k ohm resistors if thats what it is..
 
Last edited: