COOLRUNNER C14 on rev 3 ripped up

[brent1wer]

I lifted it off my rev c and I can't get it back and its my first rgh. I have a 4gb corona v4 and I got the 4gb r/w kit installed and dumped the nand and put on the post fix and when I was soldering on the 3v3 I slipped :facepalm:. So if anyone could tell me if it a capacitor and the microfarads or if it's a resistor the ohms or if it's something else or can't be replaced. Any help would be greatly appreciated, thanks.


Ps. I'll upload pics later

 

[chase]

C14 is a big capacitor .. how the heck did you rip that off ??

it is a 10uf cap in case the pads are good and you're able to replace it

 

[brent1wer]

I was putting the 3v3 on and I had a clump of solder on the tip and I didn't clean or tin the tip and I was distracted watching =3 so I moved it and there but thanks so much. I'm 13 years old and I have some experience soldering. I usually flash drives but I have a bad drive and I kinda wanted to play emulators and play around with xecuter fusion.
So thanks so much.

 

[brent1wer]

Sorry for asking more but the the lowest voltage I can find is 10 volts I'm guessing it won't matter to much if it over.
Do you guys know the voltage

 

[chase]

the original capacitor is 10uF and i think its rated at 16v so I think it will be ok if you got a 10uF cap at 10v

 

[brent1wer]

Thank you so much. You where super helpful. Now i can finish with my install

 

[chase]

good luck

 

[brent1wer]

I put it on and it didnt help. I still have a solid red light