RGH C1E18 lifted in Coronoa V6 Toshiba Nand and xbox wont turn on but still RW nands

[raulale]

Hi there,

Was trying to RGH my first XBOX 360E model. Read NAND correctly and then flashed NANDXELL. Then installed chip and then tried to turn on xbox to get cpu key, wont turn on. Remove chip and tried power again, no luck. Remove nand solder points and oscilator bridged, no luck. Resolder nand and flash with original nand, still no luck. Tried to desolder bridge and noticed that C1E18 pad was loose, eventually being lifted completely. This point was GND (i used to ground oscilator) but i cannot see any trace or alternative point to fix it.

Things to consider:

-I checked continuity with multimeter on the flex of the RF board, so i dont think that is the problem.
-I dont have a wired controller to try and turn it on with controller
-I accidentally put RF board on xbox slim ( i was RGH both xbox at the time), so i dont know if something could happen to it when i put it on a diferent xbox (diferent voltages or amperage, maybe)
-Xbox was working fine before open it
-Like i said before, i still can read and write nand correctly.
-PSU orange led, looks OK to me.


I apology in advance if im missing some guidelines in my post.
Photos were taken with S3 samsung.



this is an example of how it looks c1e18 (its a photo that i found on internet, but my board was exactly like this)




Any help will be very greatful
Thanks for your time

 

[stucknvegas]

All the RF boards on slims are interchangeable Superslim included
Is that machine a windbond ram model ...I don"t think the damaged pad is the problem
The damaged pad is used to hold a Capacitor on 250 model. I believe that's a incomplete trace run on 4 gig
I don't have that same model to test against at this time
If I am wrong and that damaged pad is causing a incomplete trace then go directly under side of that trace find that point and run a piece of wire from bottom side to top
to complete the trace

 

[raulale]

Thanks STUCKNVEGAS for your response. So after reading your answer i discarded completely that RF is damaged. So i went into jrunner, erase full nand and write original nand and vuala, xbox is now working!

Thanks for your time, i feel ashamed of this post, i dont know if its a good idea to let it or erase it, but maybe will help others who have a similar problem with traces that dont really matter.

 

[stucknvegas]

Dude I have done worse don't be embarrassed just glad your machine starts now
PS buy some TX 4-Gig QSBs I always use them saves from headaches

 

[raulale]

Thanks!

UPDATES: Now that the xbox power on again, i decided to give it a try to RGH again and after reading nand, nandxell it and chip it, now is not glitching. Reading a little bit more, turns out that i have a V7 winchester motherboard. Postfix doesnt fit (and MS probably block postout point) so chip will not work at all.

Guess i will have to wait.

More info on new motherboards is here.
http://team-xecuter.com/forums/show...ve-500GB-Fifa-15-Pack-not-compotible-with-RGH

 

[stucknvegas]

I noticed the nand and some of its Resistor points did not look familiar