Can Anyone Flash My X3 in south east England

J

jledhead

Console Guru
Nov 11, 2003
592
0
BenQ LT

Tried to update a 1.61 that I just flashed last weekend to LT, and used Jungle Flasher 1.69 to flash the first time. Seemed to be successful, but when I booted up the 360, it comes up with e64 error after showing the XBox 360 splash screen. Turned off/on a couple of times, same thing. So I opened it up again, updated to JF 1.71 and flashed again. Only thing I noticed that was different was that "BenQ LT" showed in the Target, when I did it with 1.69 it showed the firmware as "Stock".

So I flashed it again with 1.71 JF, and it looked ok again. Hooked it up...pops up with the XBox 360 logo. Put in an original game, didn't play...

So...anyone else experience this? Do I have to go back to iPrep? Haven't used it since early last year... :oops:
 
S

strucdown

Console Master
Nov 16, 2003
1,088
0
Re: BenQ LT

no you need to make sure that you defo using newest jf 1.72
and make sure you dont forget to spoof source to target its easy to forget
 
You must log in or register to reply here.