Can I take my RevC RGH2 and switch it out for the CR4 XL

[No_Bans]

The title says it all mostly. I would like to take my RGH2 Trinity and put the CR4XL into it using the same glitch method except it would be version RGH2+.
Is this possible. What will I have to to in order for it to work.

Also I was going to install the QSB's for a trinity so I can make it look clean.

 

[joshypoo]

Why would you not be able to install the CR4 into your trinity?
remove you current Glitch chip
make a new RGH2+ IMG from your nand dump.
install the CR4
did you even try to do some research?

here.
http://team-xecuter.com/forums/showthread.php?147806-CR4-XL-SLIM-Trinity-Install-Guide-(RGH2-)

 

[No_Bans]

Yea kind of I was drunk last night when posted. But so pretty mmuch I install the new chip and build a new image for RGH2+. I already have the CPU Key obviously. I suppose wiith the new method I wont have solder the original stby_clk. I dont feel confident soldering that point (in the vids I saw it looks like you dont even need that point near the HANA chip.) But if I install the trinity QSB I suppose I will you the alternate under the board does this seem right. Im confused a little bit.

 

[GeekHeat]

If the rev c was installed correctly u shud be getting 20 secs boot times in a trinity.

 

[No_Bans]

Im a perfectionist so I would prefer the best boot times i can get. I figure out what to do with the install. I have to create a new build image on my trinity with Glitch2 and CR4 selected and build image, install the chip then flash. Thanks for the help guys. I love this community.

 

[Hypotoad]

There is no cast iron guarantee on boot times is there?

 

[Oggy]

No, there isn't