Can I write to a demon with a nand-x

[whataretheyfeedingyou]

Well still got this pain of used demon.
managed to read the nand with it but unable to write back.

can I connect a nand-x and write to the demon that way through the standard points or will it just write to xbox?

 

[BL4K3Y]

It will only write to the console's NAND because the NAND-X uses SPI which runs through the Southbridge I believe.

What issue(s) are you having when trying to write a NAND back to the DemoN?

 

[whataretheyfeedingyou]

It will only write to the console's NAND because the NAND-X uses SPI which runs through the Southbridge I believe.

What issue(s) are you having when trying to write a NAND back to the DemoN?

J-runner will crash. it wrote a retail to the demon once.

unhandled exception 78 in demon toolbox

starting to think this demon has simply had it being a already used one

 

[BL4K3Y]

So you're having problems writing to the DemoN NAND, but you can write to the console's NAND just fine?

 

[whataretheyfeedingyou]

So you're having problems writing to the DemoN NAND, but you can write to the console's NAND just fine?

I was having trouble reading a few days ago but since changing the red power wire it reads the xbox one ok but and wrote a retail image to the demon just once.
now when I try to write the ECC to it it gives all these errors

 

[BL4K3Y]

Have you tried erasing the DemoN's NAND with the DemoN Toolbox?

 

[big_ted]

Should write fine to whatever nand is live at the time same way as the console does.

I'm sure I tried it when I first got a demon, there was a funny thing with the first three blocks as it read in jrunner.

Try it and let me know I might have been drunk again
Ted

 

[whataretheyfeedingyou]

ERROR: Unknown NAND-flash device id 0xFF01 reported.
Please verify correct installation!

this is what I get in demon toolbox now

---------- Post added at 21:05 ---------- Previous post was at 20:57 ----------

and it will only detect in J-runner on PC mode and I get
Failed to grab handle

 

[5kmods]

You can use your nandx to write to onboard TSOP, I dont know if you can use it to write to the DemoN.

I had a customer repair system booted both nands however Demon using USB Mini it would not read or write to the onboard TSOP however it write to the DemoN, to write to the demon We had to Hook up to the chip directly with USB micro.

hope that helps, not sure if yours is a problem with soldering or if the flasher on teh DemoN is the cause.

 

[Martin C]

Remove the DemoN and set to PC mode. Start at the very top.

 

[whataretheyfeedingyou]

this demon has long gone in the bin