can someone check this trace and tell me...

[drrellik]

I think i may have found a problem, not sure, need some expert help. thanks.

i have a 1.6 and a failed x3 install with pcb rebuild. i have since taken the entire mod out, and cleaned up all solder etc. d0 looks good as well, but found this (see attached picture) i may have messed up a trace on the lower right corner (closest to pin 2), can someone tell me if the yellow circled area is supposed to be one continuous trace? cause i do NOT have continuity here and my box frags at boot with no mod in it... thanks for your help.

 

[Martin C]

Yes it should

Martin

 

[palle]

BenQ my bad need lil help

So updating benq drive to lt+ decided to use maximus patch without reading all the way to find out its only for liteon, ended up flashing the "patched" firmware to the benq. Everything looked good poped it in and xbox wont boot. Yay! Well I pulled it all back apart, jungle flasher doesnt see it but dos does. Ive tried everything I can think of to get the drive in correct status for flashing in dos. Anybody got any ideas, or a good walk through tut on flashing benq in dos?

 

[ReMix]

Re: BenQ my bad need lil help

first try intro/device id command then power cycle the drive on the correct port (even if jungleflasher doesn't see the drive)

if that doesn't work, try lite-on erase command

 

[palle]

Re: BenQ my bad need lil help

tried both no luck