Good day all, before I start, I wanted to say that I also posted on another forum but I did not have luck and I am in need of different ideas.
I am having some issues with a corona V4. Basically, I completed an RGH and the console boots fine. Im using a Cr3lite and thereafter also converted to S-RGH and the boot time is almost instant all the time.I noticed however that I cannot create a new profile. When doing so, it shows creating profile and updating but the screen goes blank and I have restart the console. Upon restarting, I see the profile created however, when I go to the avatar editor, blank screen. Bear in mind that I am able to do the avatar update. If I connect my HDD with existing profiles, it displays the avatars correctly however, again, cannot create profiles nor enter the avatar editor. I am able to go to FSD but it crashes when starting a game. If I start a game on the NXE menu, it says unable to read disk or game failed to start.
I have reflashed to stock, but now, when I create the profiles or enter the editor, I get an E71 red dot.
I can see the 4gb nand and able to read and write. I tried doing a full erase and writing the original nand but still get the E71 and blank screen with the updflash.bin.
I can only assume there is a corruption somewhere. Is there anyway whereby I can remap to another portion of the nand. I have also created a "fresh" nand with jrunner by extracting my dump. I even used a donor nand. The console still boots perfectly. After I created a clean nand, it does not E71 but rather just blank screen and freezes.
Please note that this happens whether dashlaunch is installed or not.
Jrunner does not pick up any bad blocks when reading or writing.
I dont know what else to do. Im thinking of doing a dual nand conversion if all else fails.
P.S. I did not post pics as the console boots perfectly each and everytime. I can post in need.
Thanks all
I am having some issues with a corona V4. Basically, I completed an RGH and the console boots fine. Im using a Cr3lite and thereafter also converted to S-RGH and the boot time is almost instant all the time.I noticed however that I cannot create a new profile. When doing so, it shows creating profile and updating but the screen goes blank and I have restart the console. Upon restarting, I see the profile created however, when I go to the avatar editor, blank screen. Bear in mind that I am able to do the avatar update. If I connect my HDD with existing profiles, it displays the avatars correctly however, again, cannot create profiles nor enter the avatar editor. I am able to go to FSD but it crashes when starting a game. If I start a game on the NXE menu, it says unable to read disk or game failed to start.
I have reflashed to stock, but now, when I create the profiles or enter the editor, I get an E71 red dot.
I can see the 4gb nand and able to read and write. I tried doing a full erase and writing the original nand but still get the E71 and blank screen with the updflash.bin.
I can only assume there is a corruption somewhere. Is there anyway whereby I can remap to another portion of the nand. I have also created a "fresh" nand with jrunner by extracting my dump. I even used a donor nand. The console still boots perfectly. After I created a clean nand, it does not E71 but rather just blank screen and freezes.
Please note that this happens whether dashlaunch is installed or not.
Jrunner does not pick up any bad blocks when reading or writing.
I dont know what else to do. Im thinking of doing a dual nand conversion if all else fails.
P.S. I did not post pics as the console boots perfectly each and everytime. I can post in need.
Thanks all