Team-Xecuter Community
Hey guys,
I just bought my second license. I have a 128gb SD card that I use in this switch. I booted to SXOS and created a hidden emunand. It said it finished but when I reboot and go back in the option isn't there. I fiddled as much as I could and couldn't figure it out. I powered down, and inserted the card into my PC for formatting. Here comes the issue:
Nothing works. I tried using the diskpart clean command. It acts like it was successful but after a few seconds the card shows up and still has boot.dat and SXOS folder . I tried every partition software I can think of. Tried in Mac disk utility and also in Ubuntu gparted. Is there something I'm missing here? In Ubuntu it shows as W95 FAT32 (LBA)
I just bought my second license. I have a 128gb SD card that I use in this switch. I booted to SXOS and created a hidden emunand. It said it finished but when I reboot and go back in the option isn't there. I fiddled as much as I could and couldn't figure it out. I powered down, and inserted the card into my PC for formatting. Here comes the issue:
Nothing works. I tried using the diskpart clean command. It acts like it was successful but after a few seconds the card shows up and still has boot.dat and SXOS folder . I tried every partition software I can think of. Tried in Mac disk utility and also in Ubuntu gparted. Is there something I'm missing here? In Ubuntu it shows as W95 FAT32 (LBA)