Can't boot to xell with falcon - constant green led on rjtag

[H3M3T]

Hi.

I tried both point for cpu reset wire, and tried the variations posted in the tut thread. So far, with 4-7 ticked on, aud clamp is and 1.2v solder on, I am getting to a point where the chip will stop glitching and the green led on it will get stuck on (same with the 5-8 and 1.2v off). I did get a red light when the 2-1 was solder on the aud clamp instead of 3-1. Is the aud clamp option a must for falcons, or can I safely try the no aud clamp route?

I didn't use the rater yet.



Sorry for pic quality, damn nexus4... I'll try and provide better images if it'll help.

 

[Martin C]

[h=3]*** R-JTAG SUPPORT TEMPLATE - READ AND FOLLOW THIS BEFORE ASKING FOR ANY SUPPORT ***[/h]
Constant green means it's booted Xell.

 

[H3M3T]

Damn. That means I'm getting xell in one tick. This falcon doesn't have hdmi output working... Where is it written that constant green means xell has booted?

Thanks btw, got cpu key.

 

[Martin C]

I would suggest looking at the RoL next time as it cycles when it boots.

 

[chase]

Constant green means it's booted Xell.

I've never had constant green when xell boots or has booted.. the dbg light just stops flashing.. ??

 

[cj_goalie31]

I've never had constant green when xell boots or has booted.. the dbg light just stops flashing.. ??

The Rol will only cycle if hdmi is plugged and working. Or if you plug in a/v cables

 

[chase]

The Rol will only cycle if hdmi is plugged and working. Or if you plug in a/v cables

i know that, but this thread is about a constant green light on R-JTAg as per the title.. and Martin said "Constant green means it's booted Xell" which has never happened to me.. was just currious..

I think Martin was talking about the ROL or the center led on the rf module when xell boots

 

[cj_goalie31]

i know that, but this thread is about a constant green light on R-JTAg as per the title.. and Martin said "Constant green means it's booted Xell" which has never happened to me.. was just currious..

I think Martin was talking about the ROL or the center led on the rf module when xell boots

O sorry i thought you were the OP for some reason (should get some sleep lol) and he said his hdmi wasnt working on his console.

 

[chase]

O sorry i thought you were the OP for some reason (should get some sleep lol) and he said his hdmi wasnt working on his console.

yeah, but whether hdmi is working or not should not cause dbg light to stay on once xell or 360 boots..

 

[cj_goalie31]

yeah, but whether hdmi is working or not should not cause dbg light to stay on once xell or 360 boots..

I agree with you their. I've never seen the debug light stay on. I was simply speaking about the rol. My mistake

 

[Martin C]

The debug light always stays on for me when booting xell.