Cannot boot into X3CL - hardware problem?
Previous thread did not answer this question, so am reposting with what I learned from there...
My conifg:
Xbox 1.6
X3 soldered + Pro Switch
X3_1959 bios (v16+)
This config runs great with original drive installed (backup run fine, FTP, XBMC etc etc) - when I pull the drive cable and try to reboot with a new 160Gb Maxtor plugged-in, or NO drive at all, I frag and get an error 7 (HDD error).
I have tried booting holding down the WHITE key and just about every other key on the pad - no difference... Modified Flubber comes up, then several seconds later the greenscreen with error codes appears.
The same is true of all my other efforts to get it to boot into a drive swappable condition
I have built multiple coasters (CDR and DVDRs) from the various tutorials and none of these will boot either!
Help!? Peterle5
Previous thread did not answer this question, so am reposting with what I learned from there...
My conifg:
Xbox 1.6
X3 soldered + Pro Switch
X3_1959 bios (v16+)
This config runs great with original drive installed (backup run fine, FTP, XBMC etc etc) - when I pull the drive cable and try to reboot with a new 160Gb Maxtor plugged-in, or NO drive at all, I frag and get an error 7 (HDD error).
I have tried booting holding down the WHITE key and just about every other key on the pad - no difference... Modified Flubber comes up, then several seconds later the greenscreen with error codes appears.
The same is true of all my other efforts to get it to boot into a drive swappable condition
I have built multiple coasters (CDR and DVDRs) from the various tutorials and none of these will boot either!
Help!? Peterle5