Cant get Coolrunner to boot into Xell

[arpsachin2]

Ok so this is what I did:

1. DUmbed the nand (got 1 bad nand block error but it was same like the 10 times I tried it).

2. Created the ecc file using Multibuilder 0.3. It was successful

3. Flashed the ecc file to the box and that was successful too. (I even tried making the ecc again with pig's software and flashed that too)

4. Programmed the CL too. (again a success)

5. Installed the CL.

6. Even the green light comes on and blinks every 4-5 seconds. (red light stays on)

7. BUT NOTHING ON THE TV. I tried using composite, componenet, AND HDMI but nothing on the tv.

Here are the pics and the video.








http://www.youtube.com/watch?v=jVB49fVMqvM&feature=youtu.be

 

[MightyShots]

This maybe a stupid response but hey thought id try help out, did you flash correct file to coolrunner and are the switches in correct positions?


Sent from my iPhone 4 using Tapatalk

 

[arpsachin2]

This maybe a stupid response but hey thought id try help out, did you flash correct file to coolrunner and are the switches in correct positions?


Sent from my iPhone 4 using Tapatalk

Yes - I copied the code from the USGE file and changed it to trinity.xsvf

AND

Yes - Its on nor and Slim.

 

[MightyShots]

Try programing coolrunner with jtag tool and use jtag tool through the process, i have a trinity board too and boots fine. I used jtag tool to make ecc file, program coolrunner writing ecc and freeboot all worked first time. Failing that double check solder points. But dont change anything while using jtag tool, follow it step by step


Sent from my iPhone 4 using Tapatalk

 

[razblade77]

have u remaped the bad blocks?

 

[arpsachin2]

have u remaped the bad blocks?

Not yet. Isn't that while/after making the freeboot image?

I am still trying to get the cpu key

---------- Post added at 18:57 ---------- Previous post was at 18:56 ----------

Not yet. Isn't that while/after making the freeboot image?

I am still trying to get the cpu key

WOW
It works now.

HOW? - My component/composite is on input 2. I changed it to input 1 and then changed it to input 2 and it worked. If I keep it at input 2 it doesn't but if I change it to input 2 after booting the xbox, it does.

 

[MightyShots]

Glad you got it working mate


Sent from my iPhone 4 using Tapatalk

 

[kapil888]

try and switch it from NOR to PRG. Keep it on slim however. Some people have had luck with that

Nvm it seems you got it working

 

[steveoo1]

I would double check the soldering on the Quick solder board.
Hard to tell from the picture, but the solders look a little iffy.
The solders don't look like they attached to the Mobo.

 

[arpsachin2]

Thanks guys