ANSWERED Can't get matching dumps from Falcon

[mod-store]

I have done about 50 or so Coolrunner installs in the past, but this falcon console I have at the moment gets 4 error 250s (not that thats too unusual), but after about 10 dumps, I can't get 2 matching.

Any ideas? Don't want to risk flashing the nand without matching dumps...

 

[Krafter]

Nothing other than the obvious. Check your solder connections. If all is good then you might try a hex editor to compare.....

Sent from my DROID2 using Tapatalk

 

[Lord Cragit]

hello are your mismatching blocks on the same block(s) each time

 

[Dreamreaper]

You fitted QSB or wired, betting its down to soldering.

 

[Lord Cragit]

yes most likely soldering but i had a mismatching block on all but th6ey where all 018 so i guessed it was a bad black and everything turned out ok, i will point out it probz ya soldering and also my board was a slim

 

[Martin C]

What block was bad?

erase the block from 2 images, then compare them.