Can't read NAND

[Ubergeek]

Search the demon forums - others did this and fixed it.

 

[skater411]

what the best way to remove the demon with out removing the quick solder pads ?

 

[Martin C]

what the best way to remove the demon with out removing the quick solder pads ?

A hammer - hit it nice n hard and it will just pop off.

 

[muchose]

A hammer - hit it nice n hard and it will just pop off.

Just need to make sure you hit it in the right spot :biggrin:

 

[Slayertex6]

Don't know about the demon, but I used a cheap heat lamp to remove a cygnos.

 

[skater411]

thanks for no help

---------- Post added at 11:19 ---------- Previous post was at 11:17 ----------

well see i have error installing it DEMON
manufacturer for code FF not found

DEMON
manufacturer for code FF not found

Current: DemoN
Switching to XBOX
Success
XBOX360
manufacturer for code FF not found

Current: XBOX
Switching to DemoN
Success
DEMON
manufacturer for code FF not found

so i say point is bridge on the quicksolder pad. but im looking into just remove it an installing it back again . i just dnt won't to remove pads with the demon . If anyone could help me i really appercated it i have heatgun that on my xtrong

 

[muchose]

thanks for no help

Sorry, some questions (like yours) deserves certain answers (like ours).

It's soldered on the MB. How do you think you're gonna take it off?


And why are you highjacking this thread?

 

[skater411]

well it was the same issue so i thought i just post my issue i did not no i had to make new one my bad gosh

 

[Martin C]

Stop pissing about with hardware you can't install.

Read the card and follow the instructions.

 

[skater411]

wow thanks martin i can read but u know people have to try im sure u was not top of the line installer when u first started so u cant help me alll u just gone to tell me i cnat install it thanks

 

[Martin C]

wow thanks martin i can read but u know people have to try im sure u was not top of the line installer when u first started so u cant help me alll u just gone to tell me i cnat install it thanks

Yes and you are very trying.

No-one is forcing you to screw it up. No-one is forcing you to post here when you do. Please refrain from pestering anyone here due to your inability. We have a section for people to get stuff installed (traders section).

To ask if you can remove the DemoN without desoldering it is just plain retarded.

If you have bridged points, desolder those points and resolder.

To cap it all, you decided to hi-jack another thread rather than start your own.