Can't unlock SPI

[Wicek]

Hello,
I have CK3 lite, the drive is seen in JF as 0272(drive is connect to pc via SATA cable), if switch is set to unlock, with 10 or 5 ohm resistance. I press into/device ID. I go to Into, but JF doesn't ask me to unlock spi.

OR

If switch is set to normal, with 5 or 10 or 15 or 20 ohm resistance. I press into/device ID.
It just stays on status 0x51

Any Help guys? I didn't find this problem anywhere.
Many thanks

My unlock switch foto: http://imageshack.us/photo/my-images/17/p9170679.jpg/

 

[frazzeld]

Try this:

intro on normal - press spi - slide unlock - hear beeps - slide lock - read drive - auto load - flash - intro - press spi - outro

"power cycle where JF indicates"

 

[changbom]

if JF ask you to unlock SPI i think you use old JF. Try new one

 

[Wicek]

I use Jungle Flasher V0.1.87 beta (277) . If Switch is set to normal and I hit intro/device ID, I tried power off and on CK3 Lite(within 1 second) there is a log:

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
JungleFlasher 0.1.87 Beta (277)
Session Started Sat Sep 17 17:43:17 2011

This is a 32 bit process running on 2 x 32 bit CPUs
portio32.sys Driver Installed
portio32.sys Driver Started, thanks Schtrom !
Found 4 I/O Ports.
Found 1 Com Ports.
Found 3 windows drives C: D: F:
Found 1 CD/DVD drives F:

Drive is Slim Lite-On..

Key found in KeyDB at record (1 - slim muj)
Key is: my "xxx" key
Key has been tested and verified, thanks C4eva !
Sending Vendor Intro to port 0x01F0
Status 0x51
Re-sending Vendor Intro:
......................................................................................................................................................................................................................................................
Device Intro failed!

And It just stays on status 0x51
http://bit.ly/qNt6LJ

 

[x360ccm]

have you got the phat ticked and not slim

 

[Wicek]

I tried both (phat and slim)

 

[N.E.Modz]

I tried both (phat and slim)

some sata cards struggle with the 0272 drives. Which sata have you got? probably better off with usb pro to be honest

dale

 

[Wicek]

I have sata on motherboard. I hope it is correct type : Intel(R) 82801EB Ultra ATA-24D1

 

[x360ccm]

try this make sure phat is ticked,then Intro on normal,then slide unlock switch,it should be in vendor mode then.

if not then it prob a chipset issue

 

[bandit123]

can u take a closer pic of each solder joint individually please the 1 on the left looks like its either not joint or its bridging

 

[Wicek]

Problem solved problem was in chipset. I unlocked it on friend's pc. Thanks all

 

[kukuku]

think about x360Pro