RGH Can't Update 16747 to 17150

[AffinitiveKuma]

Ive been trying EVERYTHING to update my RGH to 17150. It boots fine on the source 16747 but when I use it to build a 17150 image, it doesnt boot. Ive tried flashing it through Xell, Simple 360 Flasher and evertything. Its a Corona v5 board and it doesnt like Flash360. Any help?

Edit - I keep having to use Jrunner to revert back to the original 16747.

 

[chase]

what are you using to build the 17150 image ?

do you have hardware flasher like nand-x or jr-programmer or can you borrow one as that may be your only option

 

[AffinitiveKuma]

I have a demon installed. Forgot to mention that.

I have been using xeBuild and Jrunner to build the images, as well as Simple 360 Flasher.

 

[chase]

hehe.. why are you using 360 flasher when you have a demon installed

flash using the demon and it should work as long as the image is ok

 

[AffinitiveKuma]

hehe.. why are you using 360 flasher when you have a demon installed

flash using the demon and it should work as long as the image is ok

How do I flash using the demon? And I think the image is good. I use nanddump1.bin from Jrunner as a source to build it then I tried using Xell to update it but it wouldn't boot as usual.

 

[chase]

plug your usb cable to the external demon switch and use j-runner to flash to the demon..

if you don't know how, check HERE

 

[panosvo]

Hi, I also have a Demon and Coolruner, with xbox 360 slim trinity. My xbox has 17150 firmware installed and I cant glitch it. I am using j-runner. My firmware reading is ok I think, cause when I flash it to my Demon it boots up ok like it should do. I enclose images to, I see that in patch0 it says 16756 and in patch1 17150, after I create xbe image patch 0 says 17150 and patch 1 nothing, is this correct? Also the system worked perfectly in the past. Also what is " Fcrt.bin Required Flag Detected"?

 

[frayed]

Hi, I also have a Demon and Coolruner, with xbox 360 slim trinity. My xbox has 17150 firmware installed and I cant glitch it. I am using j-runner. My firmware reading is ok I think, cause when I flash it to my Demon it boots up ok like it should do. I enclose images to, I see that in patch0 it says 16756 and in patch1 17150, after I create xbe image patch 0 says 17150 and patch 1 nothing, is this correct? Also the system worked perfectly in the past. Also what is " Fcrt.bin Required Flag Detected"?

dear hijacker, start your own thread if you need support

thanks