Case mod in progress.
- Thread starter Zryth
- Start date
Goldensavage
VIP Member
http://team-xecuter.com/forums/showthread.php?t=93357&page=4
You could do it white like mine that i sold.
Also, i would advise some different grade sandpaper.. Some of the edges look a little bumpy. If your going to spray a shiny slim, sand the whole case down first, as the adhesion is much better
You could do it white like mine that i sold.
Also, i would advise some different grade sandpaper.. Some of the edges look a little bumpy. If your going to spray a shiny slim, sand the whole case down first, as the adhesion is much better
explorer66
VIP Member
not a bad job mate but id seriously go over it with the sanding drum that you get with a dremel to get good straightish lines then finish it of with sandpaper
i just buy the cheap packs that you find in a local diy store that have 3 grades of sand paper
here are a few of mine and most of the work was done with the sanding drum
original xbox
http://team-xecuter.com/forums/showthread.php?t=86403
slim xbox
http://team-xecuter.com/forums/showthread.php?t=87526
there is no better feeling that making your xbox your own mate keep it up
i just buy the cheap packs that you find in a local diy store that have 3 grades of sand paper
here are a few of mine and most of the work was done with the sanding drum
original xbox
http://team-xecuter.com/forums/showthread.php?t=86403
slim xbox
http://team-xecuter.com/forums/showthread.php?t=87526
there is no better feeling that making your xbox your own mate keep it up
Your slim looks so nice :x, wish mine came out that good.
---------- Post added at 21:26 ---------- Previous post was at 21:25 ----------
Im gonna wait until i can get a cheap spare case (Just the top) and take other peoples advice and try and make it better. I Will then spray it and stuff, but i don't wanna spray mine atm as i don't really have the money to be spending on it and the sanding drums i got with my dremel are pretty crappy.
explorer66
VIP Member
yours is spot on mate, the only thing i would say with the slims is give a good inch on the left hand side of the case as you have those nobblie bits for the side covers to atach on to and it also gives you room to hot glue the plexi glass
also instead of the pointy corners when you use the cutting wheel leave a triangle in each corner then use the sanding drum to sand away those triangles and it will give you nice curved edges like this
cant wait to see your next creation keep it up mate
Ahh right, I wonder how you done the curved egdes so nicely. .. and thanksyours is spot on mate, the only thing i would say with the slims is give a good inch on the left hand side of the case as you have those nobblie bits for the side covers to atach on to and it also gives you room to hot glue the plexi glass
also instead of the pointy corners when you use the cutting wheel leave a triangle in each corner then use the sanding drum to sand away those triangles and it will give you nice curved edges like this
Link To Image
cant wait to see your next creation keep it up mate