LITEON DG-16D2S CFW Help required

[carlnw1975]

hi guys i`m flashing a 360 phat as i want to update the firmware to 2.0.
the lite on drive is running on 0.251 and i put it back to stock f/w. the problem i`m having is that i can`t see a cfw 2.0 for the lite on 0251 in the firmware pack i`ve downloaded.
any ideas as to where i can get it or if there is a different file i would have to use

 

[diaboliq20]

it's called LTPlus-025-v2.0.bin
and is in the "firmware" folder in the rar file u download

 

[DrunkenNinja]

Make sure you are running the latest version of Jungle flasher as older versions have problems detecting the latest firmwares.

 

[carlnw1975]

thanks alot guys, i did see that file but didn`t want to risk it. reps added

 

[carlnw1975]

another problem now with this, i flashed the drive to the LTPlus-025-v2.0.bin
so i thought happy days, back ups back in action until i boot my xbox up. the drive will not open or close. but if i hook it back up to usb pro/ck3 it will open and close. now i`m totally baffled??
HELP!!!

 

[vegaslightsss]

Does the power light flash when you press the eject button? Is it just stuck or you can't here it trying to open? Does it boot up to the dashboard or does it stay frozen?

 

[DrunkenNinja]

It's customary for PHAT Drives to get stuck after some time. (Be sure there is power in the drive and you hear a clunking sound when pressing eject before trying this fix) If there is no power or resposeto the eject button being pressed it is likely your drive is dead or not re-connected properly.

First to get the drive open try this

Now the drive is open it is time to have a look inside with a flash light, you will see a little black rubber pulley, gab this with a pair of tweesers and put it in a cup ov boiled water for a couple of minutes, then take the band out and run it under cold water for a few seconds, replace the band with the tweesers.

Your drive problem should now be much better or completely fixed.

 

[Dosk3n]

When youve probed it and put the chasis back on the drive, you may have screwed it on too tight causing it to stick. Happenned with me as once its too tight the metals bent a little and you need to untighten them gradually to get a good point for it to open and close.

so try unscrewing the screws slightly. I really mean a tiny bit.