RGH Checking wires Coolrunner RGH with multimeter

[mr_piacevole]

Hey guys,

How can I check the connection with multimeter?

After second or third time soldering I still get a 'looking for usb interface device, can not continue' in the JTAG tool.

I'm using:

Laptop with Windows 7 (32 bit)

Xbox 360 Phat Falcon (HDMI) Dashboard 13599
Nand X v3 (just bought new one)
Coolrunner with wires (so without the qsb)
203 watt adapter plugged in

red led on coolrunner
yellow and red led on nand x

I understand I can check the black, red and blue wire without a problem. But what about the yellow, orange and green wires?

Thank you!

 

[sick360mods]

for the nand x wires check from the bottoms solder to the nand x wire for the coolrunner from the coolrunner to the point. i would use the sound one should look like this <))). it will beep if connection is good

 

[mr_piacevole]

Thanks! This was indeed possible with the blue and the red wire. These ones are fine when I check them from the other side that I soldered.

How can I check the orange (R4B24), yellow (is under the cpu fan) and green wire (is under cpu fan)?

 

[mr_piacevole]

Anyone?