chip unprotected but wont flash HELP!

[bullpen15]

Hello again...I just got my new x3ce in the mail...it boots fine to flashbios 3.0.1 (working on a 1.6 box here and no it's not a 1.6b). I try to http the flashbios onto the chip and I get the message "Got Bios image over http, 1048576 bytes...Unknown flash! Halting". I double checked to make sure that my chip was unprotected (green light) and it is unprotected but it wont flash via http...the banks selected are on on off off off...please help!

 

[elborak]

I double checked to make sure that my chip was unprotected (green light)

green=protected, red=unprotected

 

[DJBOOBY]

if you have flashbios on bank settings on on off off off change after you get flashbios screenup then change to off on off off off so you do not flash over flashbios 3.0.1

 

[bullpen15]

Thanks I'm special apparently...I was planning on doing that...would rather write over 3.0.3 than 3.0.1...thanks for the info and the tip!!

 

[bullpen15]

Thank everyone...all is working now...you guys rock my box!!