ok i soldered and everything put all da wires to my xbox back now when i turn on my chip i see the lights but my xbox start the reaguler xbox screen what did i do wrong ? plz help
chip wont turn on help !
- Thread starter linkz2005
- Start date
Martin C wrote a pretty nice troubleshoot guide for x2.6: http://www.xbox-guru.pwp.blueyonder.co.uk/Xbox-2.6CE-Troubleshooting-Guide.htm
i read da help faq but it does not help my chip is on... da lights and everything but when i put the chip to on all the lights go on in the swicth and da thing in the front turns on .....but my xbox turns on if my chip is not there ? did i burn my chip or something ?
I'm uncertain of which wire you are talking about but you are referring to the cable with 3 wires (red, green, grey) then the red and green are optional. Green is for LAN and red is for HD indicators. You need to solder in the grey wire to your 1.6 LPC rebuild pcb as indicated from the guide that I gave to you yesterday.
You can review the guide by teamxecuter here: http://www.teamxecuter.com/x3/tutorials/x3pin16.htm. It has X3 components but the soldering parts are basically the same for X2.6
You can review the guide by teamxecuter here: http://www.teamxecuter.com/x3/tutorials/x3pin16.htm. It has X3 components but the soldering parts are basically the same for X2.6
if you look at the guide, there is a spot where you solder the d0 point to the lpc board. The board gives you a nice pad for you to solder in your grey d0 wire. If you are not using the lpc board but rebuild the lpc by wires, then yes, you need to solder it to the the motherboard at a specific point. Again, I have a feeling you are not reading the guides very closely.
extra link for you. You need to solder all spots shown on the figure: http://www.teamxecuter.com/forums/showthread.php?t=7768