alright so i got my clear cas and got it on and everything, and i noticed when the eject button lights up, it doesnt make a circle around the eject button. so i went over to the front panel of my old xbox and saw that there was a piece wrapped around the eject button. it sorta looks like this: <o> so anyways i opened up my crystal case again, and tried to put that on but it didnt fit. any suggestions or do i just not use the piece? thanks guys
clear case question
- Thread starter rhannahs
- Start date
gavster
VIP Member
Is it the official clear case or 3rd party?
If its 3rd party check to see if it was mean't to come with that piece. I have seen some that do and other that don't.
Gavster
If its 3rd party check to see if it was mean't to come with that piece. I have seen some that do and other that don't.
Gavster
its a 3rd party case, i got it off of lamma. people have said to dremel it or sand it until it gets the right size, but im not sure.,..
mine fitted fine just with a gentle persasion (spelt wrong) and I mean gentle they crack easy as **** man. But it should go on!
Redneck
VIP Member
hell yea, when puttin the screws in, tighten VERY VERY slowly, ive cracked a few being in a hurry. But now i can buy more, ~~~~READ MY SIG~~~~