Cn't read nand using nandpro

[Brungle]

Hi guys,

I'm having issues reading the nand here. qsbs have been soldered (except for the jtag ones) I've got power to the 360 and plugged in the Nand-x into usb on my pc, nand-x has red and yellow light (is this normal?). when I try the command in nandpro20d I just get info on usage (see below)???

any ideas?

thanks


C:\NandPro20d>nandpro usb:r-16 orig.bin
NandPro v2.0d by Tiros
Useage:
NandPro dev: -r# Filename (HexStartBlock HexBlockCount) ->Read
NandPro dev: -w# Filename (HexStartBlock HexBlockCount) ->Write
NandPro dev: -e# (HexStartBlock HexBlockCount) ->Erase
dev: is hardware interface usb: or lpt:
dev: can also be a filename:, to be used as a 'Virtual Nand Device'
# is nand size (16, 64, 256, 512) in MegaBytes
(Optional) block range limit, defaults to entire device
-r# Read saving file RAW (with SPARE)
-R# Read saving file without SPARE
!r# Read saving only the SPARE data
-w# Write RAW (with SPARE) file
+w# Write RAW (with SPARE) file, init SPARE, block numbers, ECC
@w# Write RAW (with SPARE) file, init block numbers, ECC
*w# Write RAW (with SPARE) file, init ECC
+W# Write while ADDING SPARE from file without SPARE
C:\NandPro20d>

 

[Brungle]

sorry about that, I managed to get it working by running it from the desktop instead.. weird, now I'm getting loads of errors reading the nand..

 

[J2G]

Brungle a are you 100% sure your solder points are good bro by that read there is alot of errors i know one or two is ok but not that many when i did a falcon i got a read like that turned out it was my solder points so i got a multimeter set the dial to sound then touched one rod red or black it dont matter to one side of the solder point on the face of the board and the to the same point on the back of the board if you dont hear a beep then its not a good solder... just a guss bro iv only done 3 Jtags now... i also used Jtag Tool - Coolshrimp with my Nand X

 

[Brungle]

Brungle a are you 100% sure your solder points are good bro by that read there is alot of errors i no one or two is ok but not that many when i did a falcon i got a read like that turned out it was my solder points so i got a multimeter set the dial to sound then touched one rod red or black it dont matter to one side of the solder point on the face of the board and the to the same point on the back of the board if you dont hear a beep then its not a good solder... just a guss bro iv only done 3 Jtags now.

many thanks for rapid response. I have re-soldered a few of the points and hey presto its working.

thanks again mate much appreciated.

 

[J2G]

NO problem Brungle glad to help out and good the hear you got it going..