now i have a question about the coolrunner will it be a permanent add-on or will it be temp. i ask this because of many forums and original pictures of the original CPLD coolrunner it was in the xbox for prolonged use, now the coolrunner needs power and the way it obtains it is through a 12, 5, 3.3v source... or the DVD drive/Ck3 products well obviously i need my dvd to function or many people will so TX can not take a gamble that some people wont so they have to include a DVD power feature is it pass through from the XBOX power ---> coolrunner ---> then the DVD drive, ... will this glitcher be required 24/7 for homebrew to boot? bc it sounds like when M$ patched the xbox they did so in more ways than just the nand to stop hacking.. so much that a glitcher would be needed.. in terms of y can i not just go back to like 9199 and be an old school jtagger
Concering Coolruner
- Thread starter powerdemon292
- Start date
Martin C
VIP Member
The coolrunner will get power from the normal wiring. There won't be any extra modification needed to your DVD power cable.
Well i still dont see the reason y it has to be permanent, i cant understand the point of running the unsigned code but in the end is it required to run the new type of hacked dash or bc of some M$ patched which in the end was supposedly erased by the nand
xbox360 hacker
BANNED
Think you should read up on the process of the coolrunner to get a bigger better picture of what it is and why its needed
Goldensavage
VIP Member
Yes, that is the idea. And only part of what you can do
SNES
N64
MAME - My favourite
AMIGA
Genesis
OMG.... Cannot wait... for Tx Coolrunner chip, and the very nice folks to code the emulators
poisins
VIP Member
You can run just Xell Reloaded (and all ELF files related to LibXenon) on Glitch hack (atm, of corse). From Xell you can run emulators and linux (ELF files, too). No unsigned XEX files (FsD, XEX Menu etc.) can be run.
Sent from my GW620 (OpenEve 2.3.4) using Tapatalk
Sent from my GW620 (OpenEve 2.3.4) using Tapatalk
I know a Jtag cable is used to program it but how many pins on the cable is needed. Later on can we use FSD and XEX Menu?
Last edited:
think its a lpt cable, like the old printers, once there is a rebooter we can prob run FSD and XEX
sure hope so
---------- Post added at 11:28 ---------- Previous post was at 11:22 ----------
Looks like Jtag cable to me check out the picture, the Slim looks like 6 pins and the Phat looks like 4 pins hard to tell
---------- Post added at 11:28 ---------- Previous post was at 11:22 ----------
Looks like Jtag cable to me check out the picture, the Slim looks like 6 pins and the Phat looks like 4 pins hard to tell
Last edited:
Martin C
VIP Member
The empty headers on the board are for the wires to go to the parts of the 360 for the reset glitch hack. The coloured wires on the left are for programming the board itself.